spudrock512 Posted June 30, 2019 Report Share Posted June 30, 2019 I have developed a process to remove autographs from jersey, and I have had some really good success with it. I also have use this method to remove puck marks on jerseys as well. What you will need: Amodex - works really well to get the Sharpie to release from the jersey Clorox Bleach Pen (Only on a White Jersey - it will ruin color jerseys!) Acetone - Needed to move the remaining residue from the jersey Towel Rag (I used old white undershirts) Here is how the jersey looked before I started to work on it. This is an Ultrafil Hawks jersey and my guess is the autograph is from the early 90's so it has been set in the jersey for a long time. Not sure who the autograph is, and I guess it doesn't matter as I personally am not a big fan of autographs. This jersey is in mint condition so I want to get this removed for customization. When getting started, you need to use the towel between the jersey - the Amodex will activate the Sharpie and will bleed through the jersey. The towel will catch this. Fold the towel at least a couple times. I have had the Sharpie good through the towel when I did not fold it once. The couple of layers will make sure you don't have to repeat the process on the other side. Use your fingernail to dig the gel into the Sharpie. This is time consuming and is a slow process. Use your rag to remove the marker as it comes off. Once I go over the entire Autograph and remove a good amount of the marker, I will flip the jersey inside out, and repeat the process. Since this is a white jersey, next I use the Clorox Bleach Pen. Again, this is only for White jersey and make sure you avoid any color areas on the jersey. If you get this on the color part of the jersey, it will bleach that area and you will ruin the jersey. I basically do the same process as before using your fingernail to get into all the areas the autograph is on. If this was a color jersey, I would just continue with the Amodex. Once I get a good amount of the jersey off, I go to the trusty Acetone to remove any remaining residue. For those that use Acetone to remove poor customization, it is the same basic idea. I would have probably use more Acetone than I did, but I ran out - on to the hardware store to get more. At this point, I use my typical cleaning process for any jersey used I get/needs to be cleaned Soak in Oxyclean Wash with light amount of detergent and Oxyclean on Delicate Cycle, cold wash/cold rinse, lowest spin cycle, hang to dry Here is the final result: As you can see, there is still a very faint indication, but much better than before. And if I hadn't run out of Acetone, it would have been perfect. In this case, whatever is left over is going to be covered by a nameplate, so I am happy with the result. As I mention, this also work on a puck marks that I tried it on. Here is a jersey that I used it on - before from The Dude before I got the jersey from him, the second picture the end result. Quote Link to comment Share on other sites More sharing options...
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.